1-888-MICH-CAT

Cat C18 ACERT Marine Generator Set (IMO II)

Request a Quote

Product Specs

Generator Set Specifications

Minimum Rating
330 ekW (418 kVA)
Maximum Rating
450 ekW (563 kVA)
Frequency
50 Hz or 60 Hz
Speed
1500 rpm (50 hz) or 1800 rpm (60 hz)
Emissions/Fuel Strategy
IMO II

Engine Specifications

Configuration
In-line 6, 4-Stroke-Cycle Diesel
Aspiration
TA, TTA
Bore
5.7 in
Stroke
7.2 in
Displacement
1106 in³
Engine Model
In-line 6, 4-Stroke-Cycle Diesel
Rotation from Flywheel End
Counterclockwise

Dimensions & Weights

Weight
4406 lb
Height
66.3 in
Length
119.7 in
Width
60.9 in

Standard Equipment

  • Air Inlet System
    • Separate circuit after-cooled (SCAC)
    • Open Crankcase Ventilation (OCV) system
    • Turbocharger, jacket water cooled
    • Turbocharger inlet, 152 mm (6 in) OD straight connection
  • Control System
    • If an EMCP panel or MGCP option is not chosen as optional equipment, then start/stop controls must be provided by the customer
    • Programmable low idle
    • Electronic diagnostics and fault logging
    • Engine Protection Mode for extended ambient conditions - EPA Tier 3 Ratings Only
    • Electronic fuel/air ratio control
  • Cooling System
    • Separate Circuit After-Cooling (SCAC) for both HEX and Keel cooled engines
    • Engine JW and SCAC Shell & Tube Heat Exchangers for HEX cooled engines
    • SCAC pump, gear driven
    • Jacket water pump, gear driven
    • Auxiliary water pump, bronze impeller, gear driven, for HEX cooled engines only
    • SCAC and JW shunt tanks for maintaining proper pump inlet pressures
  • Exhaust System
    • Water-cooled exhaust manifold & turbocharger
    • 152 mm (6 in) round flanged outlet
  • Flywheels & Flywheel Housings
    • Flywheel Housing, SAE No. 0
    • Flywheel, 18 inch, 136 teeth
    • SAE standard rotation
  • Fuel System
    • Front service simplex fuel system
    • Fuel transfer pump, gear driven
    • Manual fuel priming pump
    • Hybrid fuel line design
  • Generators And Generator Attachments
    • SR4B Random Wound
    • Permanent Magnet Excitation
    • 12 leads
    • Generator set package includes Caterpillar's Digital Voltage Regulator (CDVR)
    • Marine Class H insulation, Class F temperature rise
    • Surface mount platinum bearing and stator RTD's
    • Anti-condensation space heaters (120/240VAC, 300W, 2 elements)
    • Generator IP23 protection
    • Coastal insulation protection
  • Lube System
    • Front service simplex oil system
    • Center sump oil pan: Deep, 500hr oil change interval
    • Front and top service oil filler locations
    • Front service dipstick
    • Oil pump, gear driven
  • Mounting System
    • Formed C-channel rails, 254mm (10.0in) height
    • Four shipped loose isolators for installation below package base
  • Power Take-offs
    • Poly-V groove for alternator drive
    • NOTE: There are no standard power take-offs available
  • General
    • Front damper guard
    • Front service engine
    • Common electrical bonding point on HEX and KEEL cooled engines
    • Engine does not ship with zinc components
    • Engine is certified to D2/E2 emissions cycles
    • CERTIFIED TO 2013 EPA TIER 3 AND IMO II MARINE COMMERCIAL AUXILIARY (D2/E2 CYCLE) EMISSIONS STANDARDS.
    • NOTE: These engines are for constant speed generator set applications only, and NOT to be used for variable speed applications.

Attachments

  • Caterpillar A&p Package Options
    • Remote Panels
    • MCS Controller
    • Oil level sensor, Exhaust temperature sensor
  • Exhaust System
    • Dry Elbows
    • Water-Cooled Elbows
    • Flexible Fitting
    • Flange
    • Muffler
    • Muffler Spark Arresting
    • Rain Cap
  • Air Inlet System
    • Air Inlet Adapter
  • Charging System
    • Battery Chargers
    • Charging Alternators
    • Alternator Mounting Group
  • Control System
    • Load Sharing Attachment
  • Cooling System
    • Aux Expansion Tank Flange Kit
  • Fuel System
    • Duplex Fuel Filters
    • Flexible Fuel Lines
    • Fuel Cooler
    • Primary Fuel Filters
  • Generators And Generator Attachments
    • Low Voltage Connections
  • Lube System
    • Duplex Oil Filters
    • Sump Pump
  • Power Take-offs
    • Note: PTO Options require torsional vibration analysis
    • Crankshaft Pulleys
    • Front Stub Shaft
  • Protection System
    • Marine Classification Society and SOLAS
  • Starting System
    • Air Starting Motor
    • Electric Starting Motors - Single 24 Volt
    • Air Start Accessories
    • Starting Aids - JW Heaters
    • Battery Sets - 24 Volt - Dry

Pin It on Pinterest

Share This